Supplementary Document

May be used to comply with OSHA's Hazard Communication
Standard 29 CFR 1910.1200. Standard must be consulted for
specific requirements.
HEALTH 1 0 = INSIGNIFICANT
FLAMMABILITY 0 1 = SLIGHT
REACTIVITY 0 2= MODERATE
HEALTH HAZARDS (ACUTE):
HAZARDOUS COMPONENTS
% (wt.)
(SPECIFIC CHEMICAL IDENTITY; COMMON NAME(S)
(OPTIONAL)
Lidocaine HCI 6108-05-0 2
FLASH POINT (METHOD USED)
64.8
o
C
VENTILATION
None Required
No
PPM MG/M
3
SKIN: Flush with clear running water for a minimum of 15 minutes; if irritation persists, seek medical attention.
EYES: Flush eyes with clear running water for a minimum of 15 minutes while holding eyelids open; if irritation persists seek medical attention.
INGESTION: DO NOT induce vomiting; seek immediate medical attention.
August 13, 2013
ADDRESS (NUMBER, STREET, P.O. BOX)
887 Kensington Ave.
TELEPHONE NUMBER FOR INFORMATION
[phone]
(CITY, STATE AND ZIP CODE)
Buffalo, NY 14215
DATE PREPARED
SUPERSEDES
April 2, 2014
MANUFACTURER'S NAME
Safetec of America, Inc.
EMERGENCY TELEPHONE NUMBER (24 Hours)
[phone]
SECTION 1 - PRODUCT / COMPANY IDENTIFICATION
Page 1 of 2
IDENTITY (AS USED ON LABEL AND LIST)
Safetec® Burn Spray
SAFETY DATA SHEET
3 = HIGH
4 = EXTREME
HMIS HAZARD RATING
SAFETEC OF AMERICA
SECTION 5 - FIRE FIGHTING MEASURES
FLAMMABLE LIMITS (% Volume in Air for Lowest Flashing Component)
UEL: Not Applicable
LEL: Not Applicable
EXTINGUISHING MEDIA
Water, water spray, dry chemicals, chemical foam, CO
2
SPECIAL FIRE FIGHTING PROCEDURES
DO NOT enter confine fire space without full bunker gear (Helmet with face shield, bunker coats, gloves and rubber boots. Wear NIOSH/MSHA approved self contained breathing apparatus. Cool fire exposed containers with water.
Small spills may be flushed with large amounts of water; larger spills should be collected with approved absorbent for disposal in an appropriate container.
None known
UNUSUAL FIRE AND EXPLOSIVE HAZARDS
SECTION 6 - ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IF MATERIAL IS SPILLED OR RELEASED
OTHER PROTECTIVE CLOTHING OR EQUIPMENT
Ordinary, none required
PROTECTIVE GLOVES
Ordinary, none required
SECTION 9 - PHYSICAL/CHEMICAL PROPERTIES
BOILING POINT
SPECIFIC GRAVITY (WATER = 1)
Approximately 212
o
F
0.997
VAPOR PRESSURE (mm Hg)
MELTING POINT
Not determined
Not applicable
VAPOR DENSITY (AIR = 1)
pH
Not determined
Approximately 5.0
SOLUBILITY IN WATER
EVAPORATION RATE (IPA = 1)
Complete
Not determined
APPEARANCE AND ODOR
% VOLATILES (BY VOLUME)
Clear liquid
Not determined
Handling: Keep container(s) tightly closed when not in use. Storage: Store in cool, dry area away. Keep this and other chemicals out of reach of children.
SECTION 8 - EXPOSURE CONTROLS/PERSONAL PROTECTION
MECHANICAL (GENERAL):
LOCAL EXHAUST:
SECTION 7 - HANDLING AND STORAGE
SECTION 2 - HAZARDS IDENTIFICATION
ROUTES OF ENTRY - SIGNS AND SYMPTOMS OF EXPOSURE
SKIN: Prolonged or repeated skin contact may cause mild irritation.
None Established
None Established
SECTION 3 - COMPOSITION/INFORMATION ON INGREDIENTS
CAS #
PPM MG/M
3
OSHA PEL/STEL
ACGIH TLV/TWA/STEL
Acute effects are possible irritation and discomfort.
INGESTION: Small amounts swallowed incidental to normal handling are not likely to cause injury. Swallowing larger amounts may cause injury.
EYES: Brief contact may cause mild irritation; prolonged contact may cause moderate irritation associated with redness.
INHALATION: Inhalation of mist may cause respiratory irritation
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE:
Preexisting skin, or eye disorders may become aggravated through prolonged exposure.
INHALATION: Remove victim to fresh air. If victim has stopped breathing give artificial respiration, preferable mouth to mouth, get medical attention immediately.
This product is not known to contain a substance subject to Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA) and 40 CFR 372 at or above minimal amounts.
EMERGENCY AND FIRST AID PROCEDURES
SECTION 4 - FIRST AID MEASURES
RESPIRATORY PROTECTION
Ordinary, none required
EYE PROTECTION
Ordinary, none required
WORK/HYGIENIC PRACTICES
Practice safe work habits. Use according to label instructions.
MSDS PREPARED BY: Safetec of America, Inc., 887 Kensington Ave., Buffalo, NY 14215 [phone]
Form Revised 9/2012