SDS

May be used to comply with OSHA's Hazard Communication
Standard 29 CFR 1910.1200. Standard must be consulted for specific
requirements.
HEALTH 1 0 = INSIGNIFICANT
FLAMMABILITY 0 1 = SLIGHT
REACTIVITY 0 2= MODERATE
HEALTH HAZARDS (ACUTE):
HAZARDOUS COMPONENTS
% (wt.)
(SPECIFIC CHEMICAL IDENTITY; COMMON NAME(S)
(OPTIONAL)
Ethyl Alcohol 64-17-5 10
Benzalkonium Chloride 68391-01-5 0.13
FLASH POINT (METHOD USED)
NA
VENTILATION
Required
Yes
SECTION 4 - FIRST AID MEASURES
1000 (PEL)
PPM
CAS #
EXTINGUISHING MEDIA
Treat for surrounding material.
Firefighters should wear full protective clothing including self contained breathing apparatus.
None Established
April 1, 2014
Page 1 of 2
SUPERSEDES
SECTION 2 - HAZARDOUS IDENTIFICATION
MANUFACTURER'S NAME
Safetec of America, Inc.
DATE PREPARED
SAFETY DATA SHEET
3 = HIGH
4 = EXTREME
HMIS HAZARD RATING
SAFETEC OF AMERICA
SECTION 1 - PRODUCT / COMPANY IDENTIFICATION
IDENTITY (AS USED ON LABEL AND LIST)
Benzalkonium Chloride Antiseptic Wipe
ROUTES OF ENTRY - SIGNS AND SYMPTOMS OF EXPOSURE
ADDRESS (NUMBER, STREET, P.O. BOX)
887 Kensington Ave.
(CITY, STATE AND ZIP CODE)
Buffalo, NY 14215
Where exposure guideline levels may be exceeded, use an approved NIOSH respirator.
August 13, 2013
INGESTION: Not a normal route of exposure. Do not induce vomiting. Never give anything by mouth if victim is unconscious, or is convulsing. Obtain medical attention.
FLAMMABLE LIMITS (% Volume in Air for Lowest Flashing Component)
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE:
Preexisting skin disorders may become aggravated through prolonged exposure.
Acute N/A
INHALATION: Not a normal route of exposure. May cause respiratory tract irritation.
SECTION 6 - ACCIDENTAL RELEASE MEASURES
This product is not known to contain a substance subject to Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA) and 40 CFR 372 at or above minimal amounts.
MG/M
3
STEPS TO BE TAKEN IF MATERIAL IS SPILLED OR RELEASED
Keep unnecessary personnel away. Do not touch or walk through spilled material. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Keep people away from and upwind of spill/leak. Pick up and
discard towel.
LOCAL EXHAUST:
MECHANICAL (GENERAL):
No data
PROTECTIVE GLOVES
SECTION 8 - EXPOSURE CONTROLS/PERSONAL PROTECTION
RESPIRATORY PROTECTION
Ordinarily, none required
OTHER PROTECTIVE CLOTHING OR EQUIPMENT
Ordinarily, none required
VAPOR DENSITY (AIR = 1)
No data
SOLUBILITY IN WATER
Moderate
APPEARANCE AND ODOR
Liquid saturated on wipe
Handling: Use good industrial hygiene practices in handling this material. Keep out of reach of children. Storage: Store in a closed container away from incompatible materials.
SECTION 9 - PHYSICAL/CHEMICAL PROPERTIES
BOILING POINT
101.11
o
C
VAPOR PRESSURE (mm Hg)
SECTION 5 - FIRE FIGHTING MEASURES
SPECIAL FIRE FIGHTING PROCEDURES
NA
UNUSUAL FIRE AND EXPLOSIVE HAZARDS
UEL: NA
LEL: NA
EYES: Flush with cool water. Remove contact lenses, if applicable, and continue flushing. Obtain medical attention if irritation persists.
INGESTION: Not a normal route of exposure. May cause stomach distress, nausea or vomiting.
EYES: May cause irritation.
INHALATION: Not a normal route of exposure. If symptoms develop move victim to fresh air. If symptoms persit obtain medical attention.
SKIN: Discontinue use if irritation and redness develop. If condition persists for more than 72 hours, consult a physican.
1000 (TLV)
None Established
ACGIH TLV/TWA/STEL
SECTION 3 - COMPOSITION/INFORMATION ON INGREDIENTS
EMERGENCY AND FIRST AID PROCEDURES
SKIN: In case of skin irritation, discontinue use of the product.
SECTION 7 - HANDLING AND STORAGE
EYE PROTECTION
Follow standard industrial hygiene practices.
WORK/HYGIENIC PRACTICES
Handle in accordance with good industrial hygiene and safety practice. When using do not eat or drink.
MSDS PREPARED BY: Safetec of America, Inc., 887 Kensington Ave., Buffalo, NY 14215 (716) 895-1822
Form Revised 8/2012

Summary of content (2 pages)