User's Manual

FZ200BS Manual VERSION 0.1.0
7
FZ200BS Overview
(1) To configure the Zigbee network, set each device (FZ200BS) to Coordinator, Router and End
Device.
The initial factory set value of FZ200BS is set to Router.
(2) Do not use Broadcast accompanied by a lot of traffic in the Zigbee network unless it is vital to be
used.
It is not recommended to make a lot of traffic in the Zigbee network because it causes lots of trouble
when transmitting data and bothers to set the new route toward target devices.
(3) Do not set short time for data transmission in the Zigbee Network. The more nodes the Zigbee
Network has, the longer time for transmission time should be set.
Example.1) Zigbee Network Contribution using 10 FZ200BSs,
Set a time space to 2seconds for data transmission between FZ200BSs.
(set 2sec minimally per 10 FZ200BSs
)
Example.2) Zigbee Network Contribution using 20 FZ200BSs,
Set a time space to 4seconds for data transmission between FZ200BSs.
(set 2sec minimally per 10 FZ200BSs*2=4sec
)
It is not recommended to make a lot of traffic in the Zigbee Network.
It is not recommended to make a lot of traffic in the Zigbee network because it causes lots of trouble
when transmitting data and bothers to set the new route toward target devices.