User's Manual

FZ200BS Manual VERSION 0.1.0
35
START OK”. Target device Se-up is possible afterwards.
FZ200BS outputs “ROUTER START ERROR” or “END START ERROR” if there is no Zigbee Network
around or the Device cannot participate in the Zigbee Network.
Target device set-up is prior to data transmission.
Turn the power of FZ200BS ON, and then the Device is participated in the Zigbee Network. If
FZ200BS has its target device’s Address, FZ200BS searches if its target device is participated in the
Zigbee Network.
If the target device of FZ200BS is participated in the Zigbee Network and the target device is
properly set, “TARGET OK” is output. Data transmission becomes possible from then.
If the target device of FZ200BS is not participated in the Zigbee Network and the target device is
failed, “TARGET ERROR” is output.
When RESET OPTION is set to be enabled with a command AT+SETRESET1 , FZ200BS fails to
participate in the Zigbee Network and its target device is not properly set, FZ200BS is reset.
When RESET OPTION is set to be disabled with a command AT+SETRESET0 , FZ200BS fails to
participate in the Zigbee Network and its target device is not properly set, FZ200BS is put on standby
for a handle by users.
※ References
Appendix_1: FZx00_AT Command
Appendix_2: FZx00_GUI
Appendix_3: FZx00_End Device & ADC/KEY/GPIO