User's Manual

FZ200BS Manual VERSION 0.1.0
32
If there are a lot of Nodes in the Zigbee Network, set the space of time longer for data transmission
between the Nodes,
Especially, in case of End Device, great caution is required.
(A space of data transmission per 10 Devices: minimum 2seconds
)
The Shorter the space of data transmission is, the more traffic in the Zigbee Network is caused.
Do not change target device too often. When you set or change a target device, data for transmission
is more created to get its route. The more data there is in the Zigbee network, the more traffic is
caused.
In case thatEnd Device receives ACK data after data transmission, (For control using MICOM and data
re-transmission) set ACK data transmission receipt to be enabled by using a command AT+SETACK1.
In this situation, more traffic in the Zigbee Network is caused in comparison.
If ACK data recipe is not required after data transmission using End device (For data transmission
only), set ACK data receipt to be disabled by using a command AT+SETACK0.
In this situation, less traffic in the Zigbee Network is caused in comparison.
Do not set target device to FFFFFFFFFFFFFFFF(Broadcast) when performing data transmission.
If data is transmitted by Broadcast, all Routers in the middle transmit the data to all nodes again.
The more Devices using Broadcast data exist and the more Routers in the middle exist, the more
traffic is caused in the Zigbee Network.
Do not use Broadcast data transmission unless it is essential.
When FZ200BS performs a command to get information on Nodes participated in the Zigbee Network,
a lot of traffic in the Zigbee Network is caused.
Because Router cannot save information on all nodes in the Zigebee Network, the inquired data is
mostly transmitted by broadcast.
Broadcast data increase traffic in the Zigbee Network.
In case of you need, use AT command to inquire information on nodes in the Zigbee Network.
A lot of traffic in the Zigbee Network bothers data transmission and target device set-up
10-4. START MESSAGE
(1) START MESSAGE
It means that FZ200BS starts to operate.
START MESSAGE is output as Serial data through Serial port.
If you don’t want a Device to output the START MESSAGE, input AT command (AT+SETSTAMSG0).