User's Manual

FZ200BS Manual VERSION 0.1.0
26
HyperTerminal, FZ200BS will reset.
(2) “ROUTER START OK” and “TARGET NON” are output.
“TARGET NON” means that FZ200BS has yet to set its target device.
If “ROUTER START ERROR” is output, which means that no Zigbee Network is around, reset the
Device or check if the Coordinator’s status is okay.
(3) Router participates in the Zigbee Network and extends the Zigbee Network.
(4) Router can transmit Data.
9-3-3. Zigbee Network Participation
End Device participates in the Zigbee Network.
End Device performs data transmission in the Zigbee Network.
End Device supports Low power consumption mode.
(1) END DEVICE to set up the device's power is ON. After running
HyperTerminal, FZ200BS will reset.
(2) “END START OK” and “TARGET NON” are output.
“TARGET NON” means that FZ200BS has yet to set its target
device.
If “END START ERROR” is output, which means that no Zigbee
Network is around, reset the Device or check if the Coordinator’s status is okay.
(3) End Device participates in the Zigbee Network, and is ready to transmit Data.
9-4. Target device set-up
To transmit Data, setting a target device, which is supposed to receive the Data, is required in terms
of the Zigbee Network using FZ200BS.