User's Manual

FZ200BS Manual VERSION 0.1.0

List Initial set value

Device Name FZx00 Vx.x.x

Device Type ROUTER

Device Channel 0B

Device Transmit Power 00

UART (baud rate-data bit-parity bit-stop bit) 115200 (8, N, 1 fixed)

KEY Option 0(Disable)

ADC Option 0(Disable)

Count Option 0(Disable)

GPIO Option 0(Disable)

Internal Time 10

ACK Option 0(Disable)

Retry Option 9

Power Mode 1

Reset Option 0(Disable)

Target Device Address 0000000000000000

Link Quality Option 0(Disable)

Start Message Option 1(Enable)

Debug Message Option 0(Disable)

Battery Low Option 0(Disable)

Quick Low Power Entry 0(Disable)

To change the set values of FZ200BS, use PC Software (Window HyperTerminal, Firmtech

configuration program) after connecting FZ200BS to PC with AT Command.

Note: Please, refer to the contents in “9. Uses Guide” or “FZx00_Appendix_2_GUI” for further

information on Set-up Modification.

9. USES GUIDE

The following is a procedure for FZ200BS Set-up using Serial communication (HyperTerminal)