User's Manual

FZ200BS Manual VERSION 0.1.0
11
※ < Routing table update of FZ200BS
>
Routing table is assigned to each FZ200BS after the Zigbee Network Configuration.
Below is the Zigbee network status when data is transmitted from Router2 to Router1
to Coordinator.
Data is input into Router2, the Router2 transmits the data to Router1, and then the
Router1 transmits the data to Coordinator. Consequently, the data inputted into
Router2 is transmitted to Coordinator by routing table belonging to Router2 and
Router1
If Router 1 is in abnormal status in the Zigbee Network, Router2 cannot
transmit data, and shows its error status through ERROR port.
When ACK Option is disabled (NACK communication
) of FZ200BS, Device is
automatically reset and Router2 creates a new routing table if the Router2
happens to show its error status 5times successively through the error port
because of the abnormal Router1. Multipath set-up is required ahead of the
time to update the routing table.
When the ACK Option of FZ200BS is enabled (ACK communication
), users
should control the routing table directly to update it. If the data transmission is successively failed,
users need to reset its target device’s address (same as the existing one
) and the Device.