User's Guide

FBL700BC User Guide Version 1.0
5 Interface (Pin Connection)
페이지 9 / 12
-FA_SET / CONFIG_SELECT
If you want to enter the configuration mode, turn on the power to the module while inputting LOW Signal
(0V) to Configuration Select (No. 4 pin).
If you want to change to the factory default value, enter the LOW Signal (0V) for more than 4 seconds into
the Factory Reset (Pin No. 4) after entering the configuration mode and all setting values will be changed to
the original purchase status.
- Power Save Control Port
Select FBL700BC's Power Save ON/OFF
- Power Save Status Port
It is used to monitor the power save status of FBL700BC.
5 Interface (Pin Connection)
<Figure 5-1 Pin Connection Control>