User's Guide

FBL700BC User Guide Version 1.0
6 Interface Board (Jig Board)
페이지 10 / 12
6 Interface Board (Jig Board)
<Figure 6-1 Interface Board>
No.
Title
Description
1
UART communication & power port
UART communication interface terminal for PC connection
5V power input terminal
2
Power ON/OFF Switch
Interface Board Power On/Off Switch
3
STATUS LED
USB LED: USB port status LED
POWER LED: 3.3V power supply LED
STATUS LED: Status confirmation LED
RX LED: UART input confirmation LED
TX LED: UART Output confirmation LED
4
Configuration Select Switch
Switch for enter the configuration mode
The configuration entry mode method is as follows.
①Hold CONFIG switch and power on..
②Enter the configuration mode completed
Factory Reset Switch
Factory initialization switch
The Factory initialization is as follows.
①Enter the configuration mode
②After entering configuration mode, press the FASET
switch Hold for 4 seconds.
③Factory initialization completed
5
Connection connector
FBL700BC Connection connector
<Table 6-1 PC Interface Board>