User's Manual

FB755AC & FB755AS Version 1.0.3
- 26 -
8-2-2 How to Use PC Configuration Menu
The user will select the menu want to change. To select the menu, you may just select the
number given on the left side.
For example : To change “DEVICE NAME”, enter : [“0”]Æ[Enter]
Note : At <Figure 8-10> condition, Pressing Reset button for more than 2 seconds will reset
all the configured values to the initial status (factory preset status).
Following is the order to use the menu.
(1) The execution will only be executed by pressing the “Enter” key.
(2) The small character “t” will always move to be positioned at upper side of the menu.
(3) To move menu, use the number in the end of left side. Please be sure to “Enter” key upon
completion of input.
(4) “←” key is used to delete the entered character currently.
(5) If the entered character is unreadable or is not supported at the appropriate menu, “Retry
>” message will be output.
(6) If the input message is more than 12 characters, “Overflow buffer” message will be output
and then “Retry >” message appeared as well.
Upon completion of all PC configuration, turn off the Interface Board, switch the
Config Select switch OFF, and turn the power ON, which will start the Bluetooth to
operate normally.
Note : Please refer to Appendix A PC Configuration for the detailed description on the
configuration value.