User's Guide

FB755AC-F & FB755AS-F User Guide Version 1.1
10 Connecting the wireless section of Bluetooth
Page 19 / 31
10 Connecting the wireless section of Bluetooth
In order for Bluetooth devices to transmit data to each other, the wireless section of Bluetooth should be
connected to each other. To connect the wireless section, you should set each role for each device, one for a
MASTER, another for a SLAVE. It takes about 1~10 sec that a Master is connected to a Slave.
The connection can be done in use of AT command or connection can be set in use of connection WIZARD
because the initial connection mode of FB755AC-F & FB755AS-F is MODE4 (AT Command).
The following contents will be processed under the assumption that the FB755AC-F & FB755AS-F are
connected to the interface Board (Jig Board).
※ We will use 2 FB755AC-F & FB755AS-F and MS Windows in describing procedures.
10.1 Connecting with Connection WIZARD
※ The connection WIZARD can not be used if the DEBUG Char is set to 0x00. Please refer to the details of
environment setting in Appendix A for further details.
(1) Connect the interface board of the first FB755AC-F & FB755AS-F to the serial port of PC and switch
ON. (The selection switch of environment setting/bluetooth shall be in OFF.)
(2) Execute C-Wizard Program.
<Figure 10-1 Connection Wizard Step 1>
(3) Click FIRMTECH SLAVE Set-up button (<Figure 10-1> Blue borders)