User's Manual

FB200AS User Guide Version 1.0 10 Connecting the wireless section of Bluetooth
Page 15 / 28
10 Connecting the wireless section of Bluetooth
In order for Bluetooth devices to transmit data to each other, the wireless section of Bluetooth should be
connected to each other. To connect the wireless section, you should set each role for each device, one for a
Master, another for a Slave. It takes about 1~10 sec that a Master is connected to a Slave.
How to connect the wireless section of FB200AS can be performed with 2 significant ways.
Note :
The FB200 uses virtual COM port which shall be operated first before the Hyper Terminal is being
used so that the config tool shall be operable normally.
Please refer to the driver installation of Appendix FB200 for the instructions of driver installation of
FB200.
※ We will use 2 FB200AS and MS Windows in describing procedures.
10.1 How to connect with Dip Switch Set-up
FB200AS can perform data communication once you change the Dip Switch Set-up. The following is how to
set the Dip Switch.
(1) Set Baud rate Dip Switch of FB200AS(1) to the proper speed for communication
(2) Set FUNCTION Dip Switch #3 of FB200AS(1) to SLAVE.
(3) Turn the power of FB200AS(1) on.
(4) Set Baud rate Dip Switch of FB200AS(2) to the proper speed for communication.
(5) Set FUNCTION Dip Switch #3 of FB200AS(2) to MASTER.
(6) Turn the power of FB200AS(2) ON.
(7) If Status LED of FB200AS is turned on shortly, the wireless section of Bluetooth is properly
connected, so Data transmission can be performed.
10.2 Connecting with Connection WIZARD
(1) Connect FB200AS(1) to the USB port, and turn the power on.
(2) Execute C-Wizard Program.