User's Manual

FB155BC User Guide Version 2.1
9 Preliminary Product Components
Page 15 / 2
9 Preliminary Product Components
The preliminary value of product is set as on the <Table 9-1>.
Please be sure of basic set value and so on before using the product.
Type
Set Value
Device Name
FB155vx.x.x
Pin Code (Pass key)
BTWIN
Uart (baud rate-data bit-parity bit-stop bit)
9600-8-N-1
ROLE
SLAVE
Connection Mode
MODE4 (AT command)
Debug Char
0x02
<Table 9-1 Preliminary Configuration Setting Value for FB155BC>
To change the configuration set value of FB155BC, connect FB155BC to the PC using the PC Interface board
then, you may change using the PC software (such as Window Hyper Terminal, FIRMTECH’s PC configuration
program). With MICOM, you may change the set value by using AT command.
Note :
For details on the setting change, please refer to 10 How to complete PC Configuration.