User's Manual

FB155BC Version 2.0.0
- 23 -
8-2-2 How to Use PC Configuration Menu
The user will select the menu want to change. To select the menu, you may just select the
number given on the left side.
For example : To change “DEVICE NAME”, enter : [“0”]Æ[Enter]
Note : At <Figure 8-10> condition, Pressing FA Set button for more than 2 seconds will
reset all the configured values to the initial status (factory preset status).
Following is the order to use the menu.
(1) The execution will only be executed by pressing the “Enter” key.
(2) The small character “t” will always move to be positioned at upper side of the menu.
(3) To move menu, use the number in the end of left side. Please be sure to “Enter” key upon
completion of input.
(4) “←” key is used to delete the entered character currently.
(5) If the entered character is unreadable or is not supported at the appropriate menu, “Retry
>” message will be output.
(6) If the input message is more than 12 characters, “Overflow buffer” message will be output
and then “Retry >” message appeared as well.
Note : Please refer to Appendix A PC Configuration for the detailed description on the
configuration value.
FCC compliance Information
This device complies with part 15 of FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference received.
2. This device must accept any interference received.
Including interference that may cause undesired operation.
Modifications not expressly approved by the manufacturer could void the user’s authority
To operated the equipment under FCC rules.
Here
by, firmtech Co., LTD, declares that this FB155BC is in compliance with the essential
requirements and other relevant provisions of directive 1999/5/EC.