User's Manual

FB100AS User Guide Version 1.0 12 How to complete PC Configuration?
페이지 21 / 27
<Figure 12-4 BTConfig tool - Device Configuration >
(6) Following is to describe the procedures of setting up the config tool.
- Upon completion of all setting up, please click WRITE STATUS to store the newly set up values.
- To verify if the stored values are correct, just simply click READ STATUS to read out the current PC
Configuration stored.
- If you want to set up as it was originally received, just simply click Factory Setup, which will reset to
the initial received value.
- Since config tool is designed on the basis of AT command of the Product, which enables to look and
verify the command language with its status through status value and message window of the command
language status
Note :
Please refer to the appendix A of PC Configuration for the detailed description.
12.2 PC Configuration using Serial Communication (Hyper Terminal)
Program
12.2.1 To Execute Hyper Terminal
To set up PC Configuration using Hyper Terminal, following procedures shall be performed prior to the
power is being supplied after the FB100AS is connected to the PC.
To set up PC Configuration, the Serial Communication Program is required. We will use Hyper Terminal in
describing the procedures.
(1) Fix the number 4 switch of Function Dip Switch at ON.