Product Manual

Page 20
English Customer Service: 1-844-FIRMAN1
11. Push the choke button to the “RUN” position.
7. Flip the engine switch to the “RUN"(l) position.
6. Disconnect all electrical loads from the generator.
Never start or stop the generator with electrical
devices plugged in or turned on.
5. Turn the fuel selector switch to “LPG” position(1:30 o’clock).
9. Pull the choke lever out to the "CHOKE" position.
8. Push the battery power restore switch for about
3 seconds and then release.
4. Fully open the LPG cylinder knob.
Use your fingers, slide the outer barrel back on
the LPG quick connect hose fitting. While the outer
barrel is in the back position, insert the LPG hose
(included) into the inlet and release the outer barrel.
The barrel will automatically return and lock the
hose in the inlet.
10. PULL TO-PRIME:-
Pull the starter cord 1-2 times. Pull slowly until
resistance if felt and then pull rapidly.
12. PULL TO RUN:- -
Pull the starter cord slowly until resistance if felt
and pull rapidly to run the unit.
If the engine fails to start in 1-2 pulls with choke in the
“RUN” position, then move choke lever to “START”
position and repeat the “PULL-TO-PRIME” step.
3. Connect the regulator(A) to both LPG cylinder
and generator. Connect the power cord(B) to the
LPG regulator port. See “Connecting liquid Petroleum
Gas(LPG/Propane) ” section on page 13, 14,15.Cylinder
2. Check oil level.