Product Overview



DESCRIPTION

The SMDK-1004 is a portable palmtop display kit that facilitates the installation of the MicroM,

Flame Safeguard Control. It can also be used later to obtain operational and historical information.

The SMDK-1004 consists of an ED510 alphanumaic display; a MED2, remote daughter board and a

4 foot cable.

INSTALLATION

To install the SMDK, remove the cover from the installed MicroM. With a little force, pull the exist-

ing daughter board away from the chassis and lift up and away from its connector, located on the

chassis board. Guide the SMDK-1004 daughter board on the same conector and push onto standoff..

WARNING: Remove power when servicing the control.

FIGURE 1. PLUG-IN BOARD LOCATION AND INSTALLATION

STANDOFF

PLUG-IN BOARD

(MED SERIES)

RELEASE

DIRECTION

SMDK-1

APRIL 11, 2013

FIREYE

SERVICEMAN’S

DISPLAY

KIT

SMDK-1004

PAGE 1
 SMDK-1 APRIL 11, 2013 ® SMDK-1004 FIREYE SERVICEMAN’S DISPLAY KIT DESCRIPTION The SMDK-1004 is a portable palmtop display kit that facilitates the installation of the MicroM, Flame Safeguard Control. It can also be used later to obtain operational and historical information. The SMDK-1004 consists of an ED510 alphanumaic display; a MED2, remote daughter board and a 4 foot cable. INSTALLATION To install the SMDK, remove the cover from the installed MicroM.
PAGE 2
 REMOTE DISPLAY The MicroM provides an interface to the optional ED510 display module. The ED510 connects to the MicroM through the plug-in board using a ED580 cable. The ED580 cable is available in 2, 4, or 8 foot lengths. Part number 129-145 -1 (4 ft.), -2 (8 ft.), -4 (2 ft.) is available for remote mounting the ED510 Display Module. The ED510 Display Module is a backlit, 2 line by 16 character LCD display with keypad to provide both current operation and historical information of the MicroM.