User Manual

Firetide Instant Mesh Networks 11 February 2007
Mounting the Node
Attach the supplied backing plate to the HotPort node, using the
supplied screws. Note that the holes in the node are pre-tapped for
the supplied metric screws; do not use other screws.
Next, slide the node assembly onto the bracket, so that the four tabs
on the node assembly engage the straps on the bracket, as shown
in the photo.
Figure 6. Mounting the Node
Then tighten the four captive screws on the node assembly. This
locks the node onto the bracket. Don’t leave these screws loose; if
you do, it’s easy to knock the node off the bracket.
Figure 7. Tighten Screws