User's Manual

HotPort 3100 Series Indoor Mesh Nodes 21
Appendix D—Regulatory Notices
USA
FCC Class B Notice
FCC ID Number REP-3100-2. This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particu
-
lar installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for
help.
Modifications
Any modifications made to this device that are not approved by Firetide, Inc.
may void the authority granted to the user by the FCC to operate this equip
-
ment.
FCC Radiation Exposure Statement
The antenna used for this transmitter must be installed to provide a separa
-
tion distance of at least 35 cm from all persons and must not be co-located or
operated in conjunction with any other antenna or transmitter. OEM Integra
-
tors, end-users and installers must be provided with antenna installation
instructions and transmitter operating conditions for satisfying RF exposure
compliance.
Canadian Compliance Statement
This Class B Digital apparatus meets all the requirements of the Canadian
Interference-Causing Equipment Regulations. Cet appareil numerique de
la classe B respecte les exigences du Reglement sur le material broilleur du
Canada. This device complies with Class B Limits of Industry Canada. Opera
-
tion is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
Firetide HotPort 3100 family wireless mesh nodes are certified to the
requirements of RSS-210 for 2.4-GHz spread spectrum devices, and certified
to the requirements of RSS-210 for 5-GHz spread spectrum devices. The use
of this device in a system operating either partially or completely outdoors
may require the user to obtain a license for the system according to the
Canadian regulations. For further information, contact your local Industry
Canada office.