User's Manual

Installation and User Guide
Page 22
Restoring Default Settings
You can change or restore the default settings for your HotPoint router using the HotPoint
Manager software. You can also use the following procedure to restore the factory default
settings without HotPoint Manager.
1. Connect an Ethernet crossover cable between both Ethernet ports.
2. Plug in the HotPoint power adapter and wait for red “fault” LED to turn on and then off.
3. Unplug the HotPoint power adapter and disconnect the crossover cable. The default settings
are now restored.
HotPoint Factory Default Settings
AES Encryption: Disabled
WEP Encryption: Disabled
Mesh IP address: 192.168.224.100
Ethernet ports: All ports enabled
HotPoint Manager username: admin
HotPoint Manager password: admin
Connect a crossover cable between Ethernet ports to reset.