User's Manual

HotPoint 1000R Outdoor Wireless Mesh Router
Page 15
Mounting the Antenna
The antenna consists of an antenna shaft with an attached coaxial cable and a mounting tube.
Remove the set screw that secures the antenna shaft to the tube and separate the two
components
Note: The antenna used for this transmitter must be installed to provide a separation distance of
at least 20 cm from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter. OEM Integrators, end users and installers must be provided with
antenna installation instructions and transmitter operating conditions for satisfying RF exposure
compliance.
Wall Mounting
1. Position the mounting tube vertically above or to the side of the HotPoint 1000R enclosure to
permit easy attachment of the coaxial antenna to the connector at the top of the enclosure.
2. Use four screws to attach the mounting tube securely to the wall. Use appropriate anchors
when attaching to masonry or other materials
3. Replace the antenna shaft by first threading the coaxial cable through the tube and then
securing the shaft to the tube using the set screw.
4. Connect the end of the coaxial cable to the antenna connector at the top of the HotPoint
1000R enclosure.
Pole Mounting
1. Position the mounting tube on the pole above the HotPoint 1000R enclosure. Be sure allow
spacing for easy attachment of the coaxial antenna to the connector at the top of the
enclosure.
2. Clamp the tube securely to the pole using the two “U” bolts provided.
3. Replace the antenna shaft by first threading the coaxial cable through the tube and then
securing the shaft to the tube using the set screw.
4. Connect the end of the coaxial cable to the antenna connector at the top of the HotPoint
1000R enclosure.
HotPoint 1000R Antenna