SDS

Global Harmonized System
WT-102 Flame Retardant Coating
www.firetect.com | Firetect™, Inc. 28298 Constellation Road, Valencia, CA 91355
1/10/2018 Page 2 of 3
5. Fire-fighting measures
Suitable extinguishing media For dry solids use water foam, CO2, or dry chemical fire-fighting apparatus.
Unsuitable extinguishing media None.
Specific hazards arising from None.
the substance or mixture
Special protective equipment Closed container exposed to heat may cause rupture due
and precautions for fire-fighters to pressure build-up.
6. Accidental release measures
Personnel precautions None.
Environmental precautions Avoid runoff into storm sewers, ditches, and waterways.
Cleanup measures Flush spilled material into suitable retaining areas or containers with large
quantities of water. Small amounts may be absorbed into appropriate
absorbent. Dispose of product in accordance with applicable local, county,
state and federal regulation.
7. Handling and storage
Precautions for safe handling Avoid breathing mist. Avoid prolonged skin contact.
Engineering controls Use local exhaust ventilation if sprayed inside. Otherwise,
general ventilation is adequate.
Conditions for safe storage Store upright in original sealed containers and in a cool, dry
location away from light and strong frost.
Storage temperature Storage should not exceed 80ºF or fall below 40ºF. Do not allow to freeze.
Shelf life Shelf life is one year, if containers are unopened.
8. Exposure controls/Personal protection
Exposure controls Use appropriate engineering controls such as proper ventilation. Where such
systems are not effective, wear suitable personal protective equipment, which
performs satisfactorily and meets OSHA or other recognized standards.
Personal protective equipment
Eye/Face protection Wear goggles to avoid overspray and splashing. Eye and face
protection should be in accordance with OSHA 29 CFR 1910.133.
Hand/Arm protection Rubber or plastic gloves are recommended.
Respiratory protection Use an N-95 or P-95 mask. If sprayed, wear an air-purifying respirator approved
by NIOSH in accordance with OSHA 29 CFR 1910.134(d)(1)(ii). If used in a
confined area, a full-face, powered air-purifying respirator (PAPR) or supplied-
air respirator (SAR) is recommended. Use respirators in accordance with 29 CFR
1910.134(d)(3)(i)(A) Table 1, 29 CFR 1910.134(d)(3)(iii)(B) and 29 CFR
1910.134(d)(3)(iv)(B).
9. Physical and chemical properties
Appearance
Physical state Liquid.
Color Color base and tinted black or white.
Odor Very faint odor.
Odor threshold Not applicable.
pH
% volatile by vol
Freezing point 32°F
Boiling point 212°F
Specific gravity 1.08
Evaporation rate Less than water.
Vapor pressure None.
Vapor density Equal to water.
Flashpoint Not Applicable