Installation Manual

2580 Installation Instructions 14
FINISHING THE INSTALLATION
16
SAFELY RETURN VEHICLE TO OPERATIVE STATE
If you removed any wheels during installation, install the
wheels and torque the lug nuts to the manufacturer’s
specifications.
Safely remove any jack stands and wheel chocks used
during installation.
Re-attach the negative battery cable.
DOUBLE-CHECK AIR SPRING CLEARANCE
Check the Air Springs once again for the proper 1/2"
minimum clearance. Perform clearance check again when
vehicle is under load.
VEHICLE GVWR
NEVER exceed the maximum load recommended by the
vehicle manufacturer (GVWR). The GVWR can be found
in your vehicle’s owner’s manual or on the data plate on
the driver’s side door. Consult your local dealership for
additional GVWR specifications.
READ AND UNDERSTAND THE
OPERATING INSTRUCTIONS
The Ride-Rite system can improve handling and comfort.
Take the time to learn how to properly use and maintain
your investement by reading the Operating Instructions.
! IMPORTANT
A MINIMUM OF 5 PSI MUST BE MAINTAINED IN THE AIR SPRINGS AT ALL TIMES
Too much air pressure in the Air Springs will result in a firmer ride, while too little air pressure will allow the
Air Springs to bottom out over rough conditions, and will not provide the improvement in handling that is possible.
1/2"1/2"
USE YOUR HAND TO CHECK FOR THE
PROPER CLEARANCE AROUND THE AIR
SPRING. IF YOUR HAND DOES NOT FIT
BETWEEN THE AIR SPRING AND OTHER
COMPONENTS, IT WILL RUB!