Installation Manual

riderite.com11
INSTALLING AIR LINE TUBE INTO AIR FITTINGS AND INFLATION VALVE
ROUTE AND SECURE AIR LINE TUBES
12
13
1
Insert end of Air
Line Tube into Air
Fitting.
2
Push Air Line Tube
into Air Fitting as
far as possible.
3
Gently pull on
the Air Line Tube
to check for a
secure fit.
4
To remove, push
down collar and
gently pull Air Line
Tube away.
DO
Select routes protected from heat,
debris, and sharp edges.
Use Thermal Shields near heat sources.
Use Nylon Ties to secure the
Air Line Tube.
DON’T
Bend or sharply curve Air Line Tubes.
Leave Air Line Tube exposed to sharp edges.
Use unnecessary lengths of Air Line Tube.
Route Air Line Tube near moving parts.
Let Air Line tube hang unsecured from vehicle.
Scar Air Line Tube while routing.
Air Line Tube routes will vary, depending on your truck, and re-
quires you to choose the best path from the Air Springs to the
Inflation Valves. Use the instructions below to help you choose.
AIR LINE TUBE THERMAL SHIELD
INFLATION
VALVE
AIR LINE
TUBE
AIR
FITTING
x 6
x 2
USE SUPPLIED THERMAL SHIELDS WHEN AIR LINE
TUBE RUNS WITHIN 6 INCHES OF HEAT SOURCES.
Removal Tip: Use a 1/4ʺ, 5/16ʺ,
or 6mm open-ended wrench
to push the collar down.