Installation Manual

2580 Installation Instructions 10
1
Secure the Air Inflation
Valve Bracket to a pro-
tected, secure location.
PROCEED TO STEP 3.
2
Select a protected location to
install the Inflation Valves,
such as the bumper or the
body of the vehicle.
Drill two 5/16" holes for
Inflation Valve install
locations.
3
Install Inflation Valve
assembly as shown.
INSTALL INFLATION VALVES
CUT THE AIR LINE TUBE INTO TWO EQUAL LENGTHS
10
11
x 2 x 2x 4 x 2
1
Match Air Line Tube ends.
2
Find center of Air Line Tube,
make a square cut with tube
cutter or sharp utility knife.
LARGE
NYLON TIES
Inflation Valve
install locations.
BUMPER
INFLATION
VALVES
EXAMPLE
INFLATION VALVE
AIR LINE TUBE
VALVE CAP
INFLATION
VALVE NUT
5/16” - 16 FLAT WASHER
Vehicle body,
bumper or
Inflation Valve
Bracket.
DO
Make sure the cut is as square as possible.
Use a tube cutter or sharp utility knife.
DON’T
Fold or kink the Air Line Tube.
Cut the Air Line Tube at an angle.
Use pliers, scissors, snips,
saws, or side cutters.
Square cut
90˚
AIR LINE TUBE
AIR LINE TUBE AIR LINE TUBE AIR LINE TUBE
PROPER AND IMPROPER CUTS IN THE AIR LINE TUBE
AIR LINE TUBE
IF USING THE OPTIONAL NO-DRILL INFLATION VALVE BRACKET, CHOOSE OPTION 1. IF DRILLING,
CHOOSE OPTION 2. INFLATION VALVES MUST BE ACCESSIBLE BY AN AIR CHUCK.
5/16”