Product Manual
Table Of Contents
- SECTION 1: SAFETY
- SECTION 2: INTRODUCTION
- SECTION 3: INSTALLATION
- SECTION 4: OPERATION
- 4.01 General Safety Precautions
- 4.02 Firepower Controls
- 4.03 Flux Cored Arc Welding (FCAW)
- 4.04 Shutdown Procedures
- 4.05 Basic Welding Technique
- 4.06 Welding Gun Positions
- 4.07 Establishing the Arc and Making Weld Beads
- 4.08 Pre-Weld Procedure
- 4.09 Welding Procedure
- 4.10 Reference Table
- 4.11 Firepower FP 95 FC Welding Setting Selection Guide
- SECTION 5: SERVICE
- APPENDIX 1: OPTIONS AND ACCESSORIES
- APPENDIX 2: power supply replacement parts
- APPENDIX 3: FIREPOWER FP 95 FC SYSTEM SCHEMATIC
- Revision History
- SECTION 1: SAFETY
- SECTION 2: INTRODUCTION
- SECTION 3: INSTALLATION
- SECTION 4: OPERATION
- 4.01 General Safety Precautions
- 4.02 Firepower Controls
- 4.03 Flux Cored Arc Welding (FCAW)
- 4.04 Shutdown Procedures
- 4.05 Basic Welding Technique
- 4.06 Welding Gun Positions
- 4.07 Establishing the Arc and Making Weld Beads
- 4.08 Pre-Weld Procedure
- 4.09 Welding Procedure
- 4.10 Reference Table
- 4.11 Firepower FP 95 FC Welding Setting Selection Guide
- APPENDIX 1: OPTIONS AND ACCESSORIES
- APPENDIX 2: power supply replacement parts
- APPENDIX 3: FIREPOWER FP 95 FC SYSTEM SCHEMATIC
!
WARNING
Read and understand this entire Manual and your employer’s safety practices before install-
ing, operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judgement,
the Manufacturer assumes no liability for its use.
Firepower FP 95 Flux Cored Welder
Operating Manual Number 0-5122
Published by:
ESAB Group, Inc.
2800 Airport Rd.
Denton, TX 76208
www.repoweronline.com
Copyright 2015 by ESAB
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the
publisher is prohibited.
The publisher does not assume and hereby disclaims any liability to any party for
any loss or damage caused by any error or omission in this Manual, whether such
error results from negligence, accident, or any other cause.
For Printing Material Specification refer to document 47x1909
Original Publication Date: March 19, 2009
Revision Date: April 8, 2016
Record the following information for Warranty purposes:
Where Purchased:_______________________________ __________
Purchase Date:__________________________________ __________
Power Supply Serial #:___________________________ __________
Torch Serial #:___________________________________ __________