32991960.
132991960.qxd 24/10/2003 15:23 Pagina 2 (Nero/Process Black pellicola) Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings.
132991960.qxd 24/10/2003 15:23 Pagina 3 (Nero/Process Black pellicola) Contents For the User For the Installer Important Safety Information Your New Washing Machine Description of the Appliance Detergent dispenser drawer The Control Panel Operating sequence Washing Hints 5 5 Unpacking Positioning Water inlet Water drainage Levelling Special conditions In the interest of the environment Electrical connection Building-in 7-10 7 7 7 7 7 7 8 8 9 9 9 9 9 9 9 10 11-12 12 12 Which detergent?....
132991960.qxd 24/10/2003 15:23 Pagina 4 (Nero/Process Black pellicola) Your New Washing Machine Your new washing machine meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. ● ● Automatic cooling of the wash water to 60°C before draining, with the 95°C programme. This reduces thermal shock to fabrics, helping to prevent creasing. The special wool programme with its new delicate wash system treats your woollens with extreme care.
132991960.
132991960.qxd 24/10/2003 15:23 Pagina 6 (Nero/Process Black pellicola) The Control Panel PROGRAMMES A U T O WA S H ON/OFF 1 0 0 0 QUICK WASH RINSE HOLD HALF LOAD FWM 1000 1 2 3 4 5 6 1 Programme guide 7 5 RINSE HOLD button Press this button to make the machine stop with water in the drum after the cotton, synthetic or delicate wash cycles. This prevents any creasing which may occur if the clothes are left damp in the drum.
132991960.qxd 24/10/2003 15:23 Pagina 7 (Nero/Process Black pellicola) Operating Sequence 3. Measure out the fabric softener Before the first wash, we recommend that you run a cotton cycle at 60°C, without any laundry in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2 a measure of detergent into the dispenser drawer and start the machine. If required, pour fabric softener into the compartment marked (the amount used must not exceed the “MAX” mark in the drawer).
132991960.qxd 24/10/2003 15:23 Pagina 8 (Nero/Process Black pellicola) 6. Start the machine Before starting up the machine check that: ● the appliance is plugged in ● the water supply tap is turned on ● the drain hose is correctly and securely positioned ● the door and the detergent dispenser drawer are closed. Depress the ON/OFF button: the mains-on light will illuminate and the machine starts operating. ON/OFF P0471S 7. At the end of the programme The machine stops automatically.
132991960.qxd 24/10/2003 15:23 Pagina 9 (Nero/Process Black pellicola) 4. Select the required option WASHING 2 KG OF MIXED FABRICS AT 50°C Suppose you have 2 kg of Mixed fabrics to wash. They are rather delicate fabrics and should not be washed at a high temperature. Depress the RINSE HOLD or QUICK WASH button if your laundry is lightly soiled. 1. Load the laundry ON/OFF QUICK WASH RINSE HOLD HALF LOAD Open the door by pulling the door handle outwards.
132991960.qxd 24/10/2003 15:23 Pagina 10 (Nero/Process Black pellicola) 7. At the end of the programme The machine stops automatically. If you have depressed the RINSE HOLD button, the machine will stop with the water left in the tub, to prevent the fabric from creasing. To drain the water and spin, release the same button. To drain only, select programme “P”. The door is controlled by a safety device which releases 2 minutes after the end of the programme.
132991960.qxd 24/10/2003 15:23 Pagina 11 (Nero/Process Black pellicola) Washing Hints Do NOT overload the machine. Weigh the laundry the first few times you use the appliance.
132991960.qxd 24/10/2003 15:23 Pagina 12 (Nero/Process Black pellicola) Which detergent?.... And in which form? To ensure you obtain the best wash results from your appliance, it is important to use the right detergent in your everyday wash, and only detergents recommended for use in automatic machines.
2991960.qxd 24/10/2003 15:23 Pagina 13 (Nero/Process Black pellicola) Wash Care Symbols Wash care labels inside garments recommend how to launder your clothes with the best results. The care labelling code is in line with care labelling used in the rest of Europe. The symbols used make it easy to select the correct programme on your washing machine.
132991960.qxd 24/10/2003 15:23 Pagina 14 (Nero/Process Black pellicola) Washing Programmes Programmes for cotton and linen Wash programme/ Washing symbol Degree of soil and type of laundry Programme dial position Description Possible options Max. Progr. time load mins. A Prewash at 40 °C Wash at 95°C 3 rinses Long spin RINSE HOLD HALF LOAD 4.5 kg QUICK WASH 145 B Wash at 95 °C 3 rinses Long spin RINSE HOLD HALF LOAD 4.
132991960.qxd 24/10/2003 15:23 Pagina 15 (Nero/Process Black pellicola) Washing Programmes Programmes for synthetics, mixed fabrics, wool and delicates Possible options Max. load Progr. time mins.
132991960.qxd 24/10/2003 15:23 Pagina 16 (Nero/Process Black pellicola) Maintenance and Cleaning Before any maintenance or cleaning is carried out you must DISCONNECT the appliance from the electricity supply. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions.
132991960.qxd 24/10/2003 15:23 Pagina 17 (Nero/Process Black pellicola) The dangers of freezing Unscrew and remove the filter. Clean carefully under a fast running tap. If the machine is exposed to temperatures below 0°C, certain precautions should be taken. ● Turn off the water tap. ● Unscrew the inlet hose. ● Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hose in a bowl. Run the draining programme. ● Disconnect the appliance.
132991960.qxd 24/10/2003 15:23 Pagina 18 (Nero/Process Black pellicola) Something Not Working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
132991960.qxd 24/10/2003 15:23 Pagina 19 (Nero/Process Black pellicola) Symptom Possible causes The door will not open ● ● ● The programme is still running. The door lock has not yet released. Water in the tub: the door cannot be opened if water is present in the tub. Spinning starts late or the machine does not spin ● The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum.
132991960.
132991960.qxd 24/10/2003 15:23 Pagina 21 (Nero/Process Black pellicola) Installation Instructions It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
132991960.qxd 24/10/2003 15:23 Pagina 22 (Nero/Process Black pellicola) Unpacking Plug the open holes with the plugs supplied with the instruction booklet. All transit bolts and packing must be removed before using the appliance. You are advised to keep all the packaging for re-use in case the machine is to be transported again. Using a spanner unscrew and remove the rear right bolt. Lay the machine gently on its back, making sure that the hoses are not squashed.
132991960.qxd 24/10/2003 15:23 Pagina 23 (Nero/Process Black pellicola) Water drainage Connect the hose to a tap with a 3/4” thread. Do not use previously used hoses for water connection. This appliance is designed to be permanently plumbed into your home's water supply and drainage system. The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic “U-Piece” supplied.
132991960.qxd 24/10/2003 15:23 Pagina 24 (Nero/Process Black pellicola) Special conditions If the floor is carpeted or covered with crumbly or soft material, insert a rigid support base under the feet to prevent noise, vibration or displacement. The base should protrude a few centimetres beyond the edges of the machine. If you intend the drain hose to empty into a sink, make sure that the sink is empty and the plug hole is not blocked. Use the plastic “U-Piece” supplied.
132991960.qxd 24/10/2003 15:23 Pagina 25 (Nero/Process Black pellicola) Electrical connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. The wire coloured blue must be connected to the terminal marked «N» or coloured black. The wire coloured brown must be connected to the terminal marked «L» or coloured red.
132991960.qxd 24/10/2003 15:23 Pagina 26 (Nero/Process Black pellicola) Building-in This appliance has been designed to be built into the kitchen furniture. The recess should have the dimensions shown in picture A. The distance (B) from upper edge of the door to the centre of the hole depends on the adjacent furniture's dimensions. The required dimensions are given in the picture C. The hinges will be fixed to the door by means of screws for wood (2-Fig. B) supplied with the appliance.
132991960.qxd 24/10/2003 15:23 Pagina 27 (Nero/Process Black pellicola) Recommendations regarding the construction and fitting of a base when the installation requires an integrated appliance to be raised Fix the base firmly to the floor using four appropriate countersunk screws (see Fig. H). Where the appliance has been raised by mounting onto a wooden base provided by the installer.
