Owner's Manual

TEMPERATURE button: Turns heater
on and off.
NOTE: Press the button for 5 seconds,
4.
Press once: Touch panel
indicator becomes active.
5.
Press again until desired setting
is
reached. Digital display shows
setting circles as below:
LED Ember light button (1): Makes
the color on bottom change.
NOTE: Ember color effect stays on
until power button is turned off.
1.
Press once. Ember color eect changes
2.
Press again until desired
setting
is reached, in total 10 colors
recycling.
LED Bottom light button (2):
NOTE: Ember color effect stays on
until power button is turned off.
1.
Press once. Ember color effect
gets changes automatically.
2.
Press again Ember color effect
flashes automatically.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an
unsafe temperature, the heater will automatically turn OFF. To reset:
Unplug the power cord from the outlet.
Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes.
Inspect the fireplace to make sure no vents are blocked, or clogged with dust or
lint. If they ar
e, use a vacuum to clean the vent areas.
With the POWER switch in the OFF position, plug the power cord back into the
outlet.
If the problem continues, have your outlet and wiring inspected by a professional.
Remote Control Battery Information
This remote control uses CR2025 battery (included).
NOTICE
To improve operation, aim the remote control at the front of the fireplace. DO NOT
press the buttons too quickly. Give the unit time to respond to each command.
NEVER dispose of batteries in re. Failure to observe this precaution may result in an
explosion. Dispose of batteries at your local hazardous material processing center.
NOTICE
When the fireplace is first turned on, a slight odor may be present. This is normal and
should not occur again unless the fireplace is not used for a long period of time.
16
the temperature setting will switch from
°C to °F. Doing this will also switch from °F
to °C.
Makes the color on the bottom change/ash
automatically.
automatically.