Manualshelf

Owner's Manual

ManualsBrandsFirenado ManualsFireplacesVent Free Electric Fireplace
11121314151617181920
HARDWIRING INSTALLATION
A.
Remove the cover plate from the bottom left side
B. Remove the wire connectors from the
cord. The power cord may be discarded.of the appliance by removing the
three screws, as shown above.
HARDWIRING CONNECTION
If it is necessary to hardwire this appliance, a qualified electrician must remove the cord connection and wire
the appliance directly to the house hardwiring.
This appliance must be electrically connected and grounded in accordance with local codes, if hardwired. In
the absence of local codes, use the current CSA C22.1 CANADIAN ELEC
TRICAL CODE in Canada or the
current ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United States.
1.
Take the new cover plate, supplied in the hardware bag. Punch out the 7/8" (22.2mm) hole and install
a box connector through, into the junction box. Snap the box connector clamp onto the supply wires.
2.
Using the wire connectors, connect the ground green wires (G), the common white wires (N)
together, then the hot black wires (L) and then the refer to Figure 3.
3.
Reinstall the cover plate using the three screws, as shown in Figure1.
TURN OFF THE APPLIANCE COMPLETELY AND LET COOL BEFORE SERVICING. ONLY A QUALIFIED SERVICE
PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE.
WARNING
!
13