Owner's Manual

Table Of Contents

FN-30-SPOL

A-0305

H-0137F 9”

H-0518F 16”

H-0135F 8”

H-0517F 12.5”

H-0516F 23”

H-0512F 11”

H-0515F 29”

H-0514F 12”

Parts List

Note: Before stacking the logs, do so without the burner in operation and wait for all component pieces to be

completely cool from any testing of the burner. Always wear protective gloves when handling the gas logs or burner

components.

IMPORTANT: In the event a replacement log is needed, please reference the log breakdown below to ensure the

correct log is ordered. The total length of each log is noted next to the model number at the end of these instructions

for identifying each log accurately.

Note: The referenced placement of the smaller top logs can be changed to fit the preferences of the homeowner. Should

this be desired, take care when restacking to allow passageways for the flame to move through the top log set. Stacking

too closely together and or placing directly in the vacant space between the bottom two logs can smother the flame

potentially creating venting problems and excess sooting.

H-PC05 6”

H-PC04 5”

PAGE 1
FN-30-SPOL Note: Before stacking the logs, do so without the burner in operation and wait for all component pieces to be completely cool from any testing of the burner. Always wear protective gloves when handling the gas logs or burner components. IMPORTANT: In the event a replacement log is needed, please reference the log breakdown below to ensure the correct log is ordered.
PAGE 2
FN-30-SPOL Step 1: Place brick riser on grate towards back and centered left to right. Step 2: Then place back log H-0516F (second largest log in the set) on top of the brick riser. Place the front log H-0515F (largest log in the set) at the very front of grate and centered left to right. H-0516F H-0515F Step 3: Then place logs H-0517F, H-0518F & H-0514F as shown below. H-0518F H-0517F H-0514F Step 4: Place logs H-0137F , H-0512F, H-0135F and pine cones H-PC05 and H-PC04 as shown below.