Owner's Manual

9
FIRE FEATURE START-UP
• Unpacking the Unit: A final inspection of your product occurs at the factory to ensure a quality product is
packaged. Please re-check for possible shipping damage immediately after unpacking your burner. If the burner
is found to have some damage, contact your dealer immediately as often the shipping carrier will have a
timeframe to report damage. Please also save the packaging material the product came with as that is at times
inspected by the shipping carrier. Double check all factory connections for leaks!
• First Time Operation: Before lighting the burner, inspect the gas supply hose. If there is evidence of cuts, wear,
or abrasion, it must be replaced prior to use. Always keep your face and body as far away from the burner as
possible when lighting. Always perform a gas leak test before each use.
• Prior to using your burner, verify that all of the following are correct:
o The burner tube is free of any debris or obstruction.
o Installation of the proper gas type and regulator settings.
o The proper gas connection is complete.
o Check for gas leaks.
o Minimum clearances are maintained.
o All packaging has been removed.
o All parts and components are properly in place.
o An installer-supplied manual gas shut-off valve is fully accessible.
o LP hose is clean and inspected for cuts, wear, abrasion, or leaks. Replace if necessary.
• Caution: Never operate the burner unattended. The surface is extremely hot and someone can touch the hot
surface and be seriously injured. All gas appliances should be attended at all times.
• If you smell gas prior to lighting and gas is turned off, read “WHAT TO DO IF YOU SMELL GAS” on page 1.
• Ensure there is no debris in fire feature.
• With gas turned on, place long handled lighter or match on top of the fire feature.
• Slowly turn “ON” gas valve
• After burner lights, remove flame.
• Adjust flame to desired height.
• If burner does not light, turn valve off. Allow gas to clear, then repeat previous steps.
• If the burner does not light after several attempts, immediately close all gas valves and consult an authorized
service technician.
• Do not alter the fire feature design.
• Never leave fire feature attended by an adult that is not familiar with emergency shut-down.
• Do not place flammable materials on or near the fire feature.
• Children must be supervised when they are near the fire feature.
• Inspect the fuel supply connection (including all quick disconnect hoses) before use. Replace hose if there is
evidence of abrasion or wear.
• Do not alter or change hose and regulator. Proper hose and regulator must always be used.
• Only use “U.S. Department of Transportation” approved LP Gas cylinders.
• LP Gas cylinder supply system must be properly vented.
• Turn off LP Gas cylinder when not in use.
FIRE FEATURE SHUTDOWN
• Turn “OFF” gas valve.
• Turn OFF LP Gas cylinder if applicable.
• After cooling, cover fire pit.