Owner's Manual

7
CHECKING FOR GAS LEAKS
Perform a leak test before each use whether the gas supply has been disconnected or not. In addition, whenever the gas
is connected to the regulator or whenever any part of the gas system is disconnected or replaced, perform a leak test.
As a safety precaution, remember to always leak test your burner outdoors in a well-ventilated area. Never smoke or
permit sources of ignition in the area while doing a leak test. Do not use a flame, such as a lighted match to test for
leaks. Use a solution of soapy water.
• Prepare a leak testing solution of soapy water by mixing in a spray bottle one part liquid soap to one part water.
• Make sure the gas valve is in the OFF position.
• Turn on the gas.
• Apply the leak-testing solution by spraying it on joints of the gas delivery system. This includes all valves, pipe
connections, joints, lines and every point from the gas source to the burners.
• Blowing bubbles in the soap solution and/or there is a faint gas smell (typically gas has an egg smell) indicates
that a leak is present. Do not attempt to ignite the burner.
• Turn the valve back to the full OFF position.
• Stop a leak by tightening the loose joint and/or resealing with thread sealant or Teflon tape, removing sealant or
tape in the event of a flared connection or by replacing the faulty part with a replacement part recommended by
the manufacturer. Do not attempt to repair the cylinder valve if it is damaged. The cylinder must be discarded to
a proper LP tank location and then replaced.
• If you are unable to stop a leak turn the valve back to the full OFF position and shut off the gas supply to the
burner.
• Call an authorized gas appliance service technician or an LP gas dealer.
• Do not use the burner until the leak is corrected.
Drainage/Venting at the bottom of the Fire feature:
Venting of the Fire Feature: Without proper venting at the bottom of your fire feature, Gas will collect in the bottom
and could cause a hazardous situation. When building a fire feature such as a firepit , ADEQUATE
VENITILATION is REQUIRED. Vents should be placed on opposing sides of the fire feature to allow cross ventilation.
Ventilation should be placed near the bottom of the cavity as well as near the top of the cavity. Consult your local codes
and the local authority having jurisdiction in regards to venting your cavity. See below for more information on
ventilation:
Fire Glass Media over the Fire Pit Ring: Do not install a thick layer of fire glass over your firepit ring as it can smother the
flames and prevent the gas from escaping out of the firepit. A layer of fire glass media no more than a 1/2” inch thick on
top of the burner required. The less media on top of the burner element, the less obstruction there is to prevent the Gas
from being ignited at the top of the fire feature.