Installation Sheet

SYSTEM RESET

If the unit is connected to the power supply but the ignition

system and grill components are not functioning, a system

reset may be required.

1. Ensure the knobs are in the OFF position, the

gas supply is turned off, and the light switch

is off.

2. Disconnect the power supply cord from line power.

3. Wait 10 minutes then reconnect to line power.

4. With the light switch and gas remaining OFF, test

the ignition (inspect hot glow from each igniter) and

digital thermometer. Then test the lights.

Note: Before testing, reset the GFCI receptacle if

needed.

Note: If the unit powers up but some or all

components are not responding, reference

the TROUBLESHOOTING section.

5. Restore the gas supply once the unit is fully

functioning.

Fig. 39-1 Disconnect from line power

DISCONNECT

(Wait 10 minutes

before reconnecting)

SERVICING AND CLEANING (Cont.)