Installation Sheet

23
The drip collector allows you to brush or scrape
residue from the grill's inner liner into the drip
trays. Following the manufacturers instructions
and regular cleaning of the grill's interior with
oven cleaner, will help to prevent grease fi res.
Your grill includes a pack of four (4) Fire Magic
®
drip tray liners (Fig. 23-1). For your convenience
in cleanup, place a liner into the drip tray (gas grill
side only) before grilling.
To fi t a liner into the drip tray, pull out the tray and
set it on a fl at, level surface. Place the liner in the
drip tray as shown in Fig. 23-2 and carefully insert
the tray back under the control panel.
Note: Be sure that the liner is properly placed into
the drip tray. The front of the liner must fi t
under the drip tray's lighting instruction plate
tabs (see 23-3 detail).
After each use, wait for the grill to cool and carefully
pull out the drip tray to check it. When a liner is
nearing full, carefully lift it out of the drip tray, lifting
with both hands to keep the tray level until it is safely
discarded. Then insert a new drip tray liner.
Order more drip tray liners through your local Fire
Magic
®
dealer.
Note: The foil tray liner is also useful for setting on
burners to cover them and catch drippings
directly during rotisserie only cooking.
Note: For models with match holders attached
inside the drip tray, place the match holder
off to one edge of the pan (Fig. 23-3). If
necessary, mold the foil liner around them
and the other features of the tray to create
enough clearance space to open and close
the tray without catching the liner.
Fig. 23-1
Fig. 23-2 Pull out the drip tray and place liner
Fig. 23-3 Fit liner under plate
Note: There are easy to follow lighting instructions
etched onto the top of the drip tray handle.
CHARCOAL DRIP TRAY
After each use, wait for the grill to cool and carefully
pull out the charcoal drip tray to check it. When
nearing full, carefully pull out the drip tray, lifting
with both hands to keep the tray level until it is
safely discarded.
Note: The charcoal drip tray has a heatshield
to protect from over heating. It may be
necessary to remove the heatshield to
properly clean out the charcoal drip tray.
When reinstalling, the heatshield dimples
must face downward as shown in Fig. 23-5.
The grill serial number tag can be found affi xed
to the grill body behind the control panel (on an
aluminum tag) and on the underside of the drip tray
handle (gas grill side). It is recommended that the
drip tray fi rst be removed and cleaned / emptied
of its contents, then turned over to view. The unit
rating label is located inside the control panel.
DIMPLES MUST FACE
DOWNWARD
Fig. 23-5
Fig. 23-4 Remove charcoal tray, clean contents
Fig. 23-5 Charcoal drip tray heatshield placement
FIRE MAGIC
®
DRIP TRAY