Installation Sheet

15
MODEL SPECIFICATIONS (cont.)
COUNTERTOP OVERHANG
The control panel is designed to sit fl ush against the grill enclosure front wall. If the non-combustible enclosure
countertop extends beyond the front wall, creating a countertop overhang, it must be cut fl ush with the front wall
for the width of the control panel or a gap will be created exposing the forward portions of the left and right side
grill fi re walls. See illustrations above.
ENCLOSURE VENTILATION
FOR YOUR SAFETY, you must provide openings in the grill enclosure for replacement air and ventilation (in
case of possible leakage from gas connections or propane cylinders). Failure to do so may result in a fi re or
explosion causing property damage, bodily injury, or death. See the GRILL ENCLOSURE / VENTILATION
REQUIREMENTS section for details.
* Note: If installing this grill in a combustible enclosure, the correct insulating liner must be used. Consult liner instructions for
counter cut-out dimensions and installation.
†
Includes any substrate at front wall of enclosure (in the area the rear of the control panel is to sit fl ush against). See SUBSTRATE
section on next page.
‡
Only applicable for non-combustible enclosures that have countertops with an overhang (see illustration and section below).
TOP VIEW
Countertop
Lower support
Countertop
overhang
Control panel
NON-COMBUSTIBLE
GRILL ENCLOSURE
CUT-OUT DIMENSIONS
Fig. 15-1
FRONT VIEW
B
C
D
See next page
for substrate
considerations
Countertop
overhang
X
TOP VIEW
SIDE VIEW
Countertop
overhang
(Control
panel)
(Countertop)
Y
1
/
4
"
Clearance
(Overhang)
X= D-B
÷
2
Y= Total
Countertop
Overhang
A
Control
panel
Check clearance for
control panel removal
CUTOUT DIMENSIONS TABLE
A Countertop to unit bottom cut-out 12"
B Side to side non-combustible cut-out 50-
1
/
4
"
C Front to back non-combustible cut-out† 19-
1
/
2
"
D Control panel width cut-out‡ 51-
1
/
4
"
†
Includes any substrate at front wall of enclosure (in the area the rear of the control panel is to sit fl ush against). See
SUBSTRATE section on next page.
‡
Only applicable for enclosures that have countertops with an overhang (see illustration and section below).