User's Guide

ADDENDUM TO OEM GUIDANCE [INTENDED TO BE ATTACHED TO USER GUIDE AFTER

EXISTING HOST DEVICE LABELING SECTION.]

RF Exposure Considerations

This module is intended for use only in the SlateSafety BAND V2 host device. The SlateSafety

BAND V2 is a portable host device that is placed on the upper arm. In the host device, all

antennas are at least 6.18mm from the body of the user. Firmware on the module must ensure

that the duty cycle of the module’s transmissions stays below .278% in a given 30 minute

window. There shall also be ﬁrmware controls that prevent the module from transmitting at the

same time as other radios inside of the host device. The SlateSafety BAND V2 also contains a

separate 2.45 GHz transmitter which is controlled by the module.

Labeling Guidance

The host device shall be properly labeled to identify the modules within the host device. The

certiﬁcation label of the module shall be clearly visible at all times when installed in the host

device, otherwise the host device must be labeled to display the FCC ID of the module, preceded

by the words "Contains transmitter module", or the word "Contains", or similar wording

expressing the same meaning, as follows: Contains FCC ID: 2A3579160

PAGE 1
ADDENDUM TO OEM GUIDANCE [INTENDED TO BE ATTACHED TO USER GUIDE AFTER EXISTING HOST DEVICE LABELING SECTION.] RF Exposure Considerations This module is intended for use only in the SlateSafety BAND V2 host device. The SlateSafety BAND V2 is a portable host device that is placed on the upper arm. In the host device, all antennas are at least 6.18mm from the body of the user. Firmware on the module must ensure that the duty cycle of the module’s transmissions stays below .278% in a given 30 minute window.