Instructions / Assembly

Part Number 18143, D, 11/07/2017

Installation

Installing the Display Unit (P1BR-S01-D/P1CR-S01-D & P2BS-S01D)

The Display Unit should be located at the instrument panel, so that the visible and

audible indicators may be easily observed.

Drill a 2-1/16” hole to accommodate the P1BR-S01-D/P1CR-S01-D Display Unit.

Drill a 2-1/8” hole to accommodate the P2BS-S01-D Display Unit.

Insert Display Unit into hole and secure with the provided threaded mounting nut.

NOTE

DO NOT MAKE ELECTRICAL CONNECTIONS AT THIS TIME. THEY WILL BE ADDRESSED IN A LATER

SECTION.

Installing the Solenoid Valve (SV-1) for LPG Applications

The Solenoid Valve should be mounted on the tank side of the LPG regulator, as close to

the tank as practical. The tank itself should be mounted outside the cabin or crew

quarters to avoid the possibility of gas accumulation due to a leak.

NOTE

TIGHTEN TO 12-13 FT/LBS. DO NOT OVER-TIGHTEN.

NOTE

ALL PIPING MUST BE CHECKED FOR LEAKS. USE SOAPY WATER SOLUTION ON ALL

JOINTS. NEVER USE A FLAME TO CHECK FOR LEAKS.

Routing Sensor Cable(s) (FS-X01 CABLE XX’)

A 20 FT Sensor Cable is provided for each Propane Fume Sensor. The Sensor Cables

should be routed starting at the Display Unit, then to the pre-determined location of the

Propane Fume Sensor. Connect to the Display Unit using the attached quick-disconnect

connectors. Take care not to pinch, break, or cut the Sensor Cable or put too much

stress on the connectors while routing the cable. Secure the Sensor Cable with the

appropriate hardware for the application.

NOTE

DO NOT CUT EXTENSION CABLE FOR ANY PURPOSE. DOING SO VOIDS THE PRODUCTS

WARRANTY. LONGER CABLES ARE AVAILABLE FROM 20 FT TO 100 FT.