Propane Fume Detection System Single Channel Systems P-1B-R (Black, Round) P-1C-R (Chrome, Round) Owner’s Manual & Installation Instructions Read and comply with all instructions, warnings and limitations before installing, servicing or removing this device.
Additional copies of this manual are available at no charge by contacting the manufacturer, distributor or dealer. Fireboy-Xintex reserves the right to change features without notice.
General Information WARNING PROPANE FUME DETECTORS ARE MEANT TO SERVE AS A SUPPLEMENTAL WARNING SYSTEM. IT IS NOT MEANT TO REPLACE STANDARD SAFETY PRACTICES WHICH SHOULD BE CARRIED OUT AROUND EXPLOSIVE GASES. The P-1B-R and P-1C-R Propane Fume Detectors are an effective means to monitor propane fumes in a compartment or leaking fuel systems. The system uses a sensor, located in a place of interest, and a central display unit that notifies you of the state of the system.
Operation of Xintex Propane Fume Detector(s) There are 3 LEDs located on the Display Unit for each channel on the system. The Green LED, located at the top, indicates that the system is operational. The Yellow LED, located in the center, indicates that there is a Fault in the system. This is to notify the user to check the connections and wire runs of the sensors. There may be a break in the wiring or a disconnected sensor on that channel.
Part Number 18142, B, 01/27/2017 P1BR-N01-D P1CR-N01-D BLACK – Ground (-) RED – Power (+) FS-X01 CABLE XX’ 1.
Installation Installing the Display Unit (P1BR-N01-D/P1CR-N01-D) The Display Unit should be located at the instrument panel, so that the visible and audible indicators may be easily observed. Drill a 2-1/16” hole to accommodate the P1BR-N01-D/P1CR-N01-D Display Unit. Insert Display Unit into hole and secure with the provided threaded mounting nut. NOTE DO NOT MAKE ELECTRICAL CONNECTIONS AT THIS TIME. THEY WILL BE ADDRESSED IN A LATER SECTION.
Installation Continued Electrical Connections (P1BR-N01-D/P1CR-N01-D) The Display Unit operates on 9-30 VDC. A Red and a Black 16 GA wire are provided for connecting to the power source. Connect the Red wire to Power (+) with an inline 1.0 Amp fuse. Connect the Black wire to Ground (-). NOTE IMPROPER CONNECTIONS WILL DAMAGE THE DISPLAY UNIT AND WILL VOID WARRANTY. Testing the System Operation The Propane Fume Detectors can be tested by pressing the “Check/Reset” button on the face of the Display Unit.
In the Event of an Alarm Immediately have all passengers and crew exit the passenger compartment and vessel if possible. Ventilate the space being monitored. Carefully check all fuel lines and other potential sources of propane fume leaks. If leaks are identified, shut off fuel supply and make any necessary repairs. Repairing Xintex Propane Fume Detection Components Xintex Propane Fume Detection Components are not field serviceable. Components must be returned to the factory for any repairs.
1 Year Limited Warranty This Warranty is in lieu of all other expressed or implied Warranties Seller warrants title, materials, and workmanship on equipment, except components manufactured by others for which the Seller assigns, as permitted, the original manufacturer’s warranty.
