User manual

8
POWER PACK
ACTIVATION
See diagram opposite
a Your detector comes complete with an
integratedpowerpackthatwillprovide
power for its entire operational life. To
activatethepowerpackyouneedtopull
the disabling tab (see image). This will in
turn pull out the metal disabling clip, which
is attached to the end of the tab, from
thedisablingsocketwhichissituatedon
the underside of the detector. Retain the
disabling tab for future use by taping it to
page 22 of this manual.
b When the detector is activated the screen
will display all of the icons, then after a
few seconds will show the current CO
level. The power indicator LED below the
symbol will also flash green once
every minute to indicate that the detector
isreceivingpowerfromthepowerpack
and is fully operational. A symbol
will also flash briefly on the LCD screen
approximately once every minute.
cTestthesounder,powerpackandcircuitry
by pushing the centre of the Test/Mode
button briefly to confirm that the detector is
operating properly. The sounder will sound
as soon as the button is pressed, and the
Alarm LED will illuminate red indicating
thatthesounderisworkingandthepower
packisprovidingpowertotheunit.
You’ll notice that the display will switch to
temperature mode, this is explained later in
the manual, press the button again to return
to the CO display. This test for the sounder,
powerpackandcircuitryshouldbe
performedonaweeklybasisandshould
be continued for the lifetime of the product.
WARNING: Prolonged exposure to the
sounder in close proximity to your ears
may damage your hearing.
Under normal operating conditions, the power
packwilllastforthelifetimeoftheproducti.e.
7 years.
Thedetectorwillnotprotectagainsttheriskof
carbon monoxide poisoning when the power
packhasdrained.
WARNING: Prolonged exposure to
extreme high or low temperatures may
reduce the life of the power pack.