Owner Manual

ASSEMBLY

Attach Mesh Guards

to Supports D/E. (HINT: It is

best to begin with bottom pieces of Mesh Guards.)

Locate one Mesh Guard. Slide the Mesh Guard

Connectors

up the Support and hold them in the center

of the Support. Insert the longer tabs at the bottom of the

Mesh Guard into the holes on Tank Housing/Base. Insert

the shorter tabs at the top of the Mesh Guard into the holes

on the Mesh Guard Connector. Repeat with 3 remaining

lower Mesh Guards. Attach upper Mesh Guards by

inserting longer tabs at the top of the Mesh Guard through

the holes in Emitter and slide the shorter tabs on the

bottom end of the upper Mesh Guard into holes in the

Mesh Guard Connectors. Then secure the Mesh Guard by

inserting the top rung into the fastener piece pre-

assembled on the Emitter (see Fig. A).

Before placing LPG tank onto base of heater, attach

Cylinder Holder K to base using 3 Bolts

Use a standard 20 lb. propane tank only. Screw the Regulator/

Hose Assembly L to the LPG cylinder (not included). Do not

cross-thread. Hand-tighten securely. Then attach the

Regulator/Hose Assembly to the end of the hose that extends

from the Burner. Do not cross-thread. Hand-tighten securely,

then tighten with a wrench. Place LPG Tank into the Cylinder

Holder and tighten the screws in the Cylinder Holder to secure

LPG tank on base.

NOTE: Use this heater only with a propane vapor withdrawal

supply system. See chapter 5 of the standard for storage and

handling of liquefied petroleum gas, ANSI/NFPA 58. Your

local library or fire department should have this book.

Fig. A

Hardware Used:

M6x12 Bolt x3