Owner Manual

Contact us for assistance: [phone] | www.wtliving.com 6
ASSEMBLY
3
Fit the Emitter
C
down over the threaded end of the
assembled Supports D by aligning the holes in the
corners of the Emitter with the Supports and sliding the
Emitter down over the Supports.
4
Secure Emitter
C
to Supports
D
using 4 Spacers
B
.
Tighten with an open-end wrench.
5
Attach Reflector
B
to top of Supports D. Align holes in
bottom of Reflector with Supports and slide Reflector
Hardware Used:
B
M8 Spacer x4
5
down over Supports. Secure Reflector to Supports with 4
Nuts
A
. Tighten with an open-end wrench.
Hardware Used:
A
M8 Nut x4