Owner Manual

Contact us for assistance: [phone] | www.wtliving.com 5
ASSEMBLY
1
Locate 4 Upper Supports D and 4 Lower Supports E.
Slide 1 Mesh Guard Connector
D
over bottom end of
Upper Support, then screw Upper Support onto Lower
Support (NOTE: Mesh Guard Connector will remain loose
and able to slide on the supports.) Repeat with remaining
Upper and Lower Supports and Mesh Guard Connectors
until you have 4 assembled supports.
Hardware Used:
D
Mesh Guard Connector x4
2
Attach the assembled Supports
D/E
to the Tank
Housing/Base
J
. Screw the Supports into the holes
located on the top of the Tank Housing/Base. (NOTE: Use the
short threaded end located on the bottom of the Lower
Support to attach the Supports to the Tank Housing/Base
Assembly. The long threaded end on the Upper Support is to
attach the Emitter and Reflector.) Mesh Guard Connectors
should rest on the top of Tank Housing after you attach the
Supports to the Tank Housing.
PREPARATION
Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents
list and hardware contents as listed on page 4 of this manual. If any part is missing or damaged, do not attempt to
assemble this product. Contact customer service for replacement parts.
ESTIMATED ASSEMBLY TIME: 60 minutes
Tools Required for Assembly (NOT included):
• Phillips screwdriver w/medium blade
• Leak test solution (see page 10)
• Adjustable Wrench (14mm wrench or socket should fit)