Owner Manual

Contact us for assistance: [phone] | www.wtliving.com 11
OPERATING INSTRUCTIONS
LIGHTING
NOTE: For initial start or after any cylinder change, hold the control knob in for 2
minutes to purge air from all gas lines before proceeding.
NOTE: This heater has an Electronic Ignition and requires installation of 1 - AAA
battery behind the red Igniter Button.
1. Turn the control knob to the “OFF” position.
2. Fully open the LPG tank valve.
3. Push in and turn the control knob clockwise to the small flame symbol (MIN) .
4. Hold control knob in, then push the RED igniter button simultaneously to ignite the
burner. Repeat until the burner ignites. Keep the control knob fully depressed for
an additional 10-20 seconds after the burner lights, then release the control knob.
5. To increase the flame, turn the control knob clockwise towards the large flame
symbol (MAX) . To decrease the flame, turn the control knob counter-clockwise
towards MIN.
6. To turn the appliance OFF, turn the control knob clockwise to the OFF position.
7. Wait at least 5 minutes before attempting to re-light the heater.
8. Turn the gas cylinder valve to OFF or closed.
WHEN HEATER IS ON:
Emitter screen will become bright
red due to intense heat. The color
is more visible at night. Burner will
display tongues of blue and yellow
flames. These flames should not
produce thick black smoke,
indicating an obstruction of airflow
through the burners. The flame
should be blue with straight
yellow tops. If excessive flame is
detected, turn off heater and
consult the “Troubleshooting”
section of this manual.
RE-LIGHTING:
Note: For your safety, the control
knob cannot be turned OFF
without rst depressing the
control knob and then rotating
to OFF.
1. Turn control knob to OFF.
2. Wait at least 5 minutes to
allow gas to dissipate before
re-lighting.
3. Repeat the “Lighting” steps
listed above.
If you experience any ignition problems, please consult the “Troubleshooting”
section of this manual.
Caution: Avoid inhaling fumes emitted from the heater’s first use. Both smoke and
odor
from the burning of oils used in the manufacturing will appear. Both smoke
and odor will dissipate after approximately 30 minutes. The heater should NOT
produce thick black smoke.
WARNING:
FOR YOUR SAFETY
Be careful
if attempting to manually ignite this
heater. Holding in the control knob for more
than 10 seconds before ignition will cause a
ball of flame upon ignition.
WARNING:
FOR YOUR SAFETY
Heater will be hot after use. Handle with
extreme
care.
SHUT DOWN
1. Turn the control knob clockwise to the “OFF” position while depressing the knob.
(The burner may make a slight popping noise when extinguished.)
2. Turn the gas cylinder valve to OFF or closed and disconnect regulator when heater
is not in use
NOTE: After use, some discoloration of the emitter screen is normal.
WARNING
•
Do NOT touch or move heater for at least
45 minutes after use.
•
Reector is hot to the touch.
•
Allow reector to cool before touching.
FOR YOUR SAFETY