Owner Manual

8. Assemble Glass Tube. Locate Glass Tube Connector (G) and

two pieces of Glass Tube (H). Carefully insert one end of Glass

Tube Connector into open end of Glass Tube and then repeat with

other Glass Tube.

9. Insert Glass Tube into Emitter and Tank Housing/Base

Assembly. Carefully insert assembled Glass Tube into end

of Emitter and then into hole on top of the Tank Housing/Base

Assembly.

10. Attach Mesh Guards to Supports.

Hint: It is best to begin with bottom pieces of Mesh

Guards.

Locate one Mesh Guard. Slide the Mesh Guard

Connectors up the Support and hold them in the

center of the Support. Then insert the longer tabs at

the bottom of the Mesh Guard into the holes on Tank

Housing/Base. Insert the shorter tabs at the top of the

Mesh Guard into the holes on the Mesh Guard

Connector. Repeat with three more Mesh Guards on

lower row. Attach upper Mesh Guards by inserting

longer tabs at the top of the Mesh Guard through the

holes in Emitter and slide the tabs on the bottom end

of the upper Mesh Guard into holes in the Mesh Guard

Connectors. Then secure the Mesh Guard by inserting

the top rung into the fastener piece pre-assembled on

the Emitter (see Fig A).

ASSEMBLY

Fig. A