Owner Manual
Contact us for assistance: (866) 985-7877 | www.wtliving.com 7
Assemble
A
with
B
.
come packaged in two brown boxes with two panels in each box. Hardware for
assembly is already axed to each panel. Place two panels side by side and remove
the two cap nuts and washers that are axed to one panel. Insert the axed bolts
into the open holes on the adjacent panel. Place the washer over the bolt and screw
on cap nut. Repeat these steps unl all four panels are assembled. Then locate the
. You will need to remove the cap nuts and washers located at
the top of each Reector Panel to allow assembly of the Center Cap on each panel.
Align the holes in the Center Cap with the bolts on each panel and ax washer and
cap nut to complete assembly.
While supporng heater, lt the
C
and slide the assembled
over the 3 bolts that extend from the Use the 3
Q
and 3
S
to secure the assembled to the
of the heater. Once you have ghtened the , return the heater
to an upright posion.
Hardware Used: 3x M8 Wing Nut
3x M8 Washer
Connect the and to the LP cylinder. The LP cylinder is sold
separately. Use a standard 20 lb. propane cylinder only. Li the
D
up and rest it on the top of the assembled
J
. Screw
G
onto
E
. Do not cross-thread. Hand-ghten securely. Aach
G
to valve on LP cylinder and hand-ghten securely. Place LP tank onto base of
heater and secure on base by hooking
I
onto the
J
. Lower the . NOTE: Use this heater only with a propane vapor
withdrawal supply system. See chapter 5 of the standard for storage and handling
of liqueed petroleum gas, ANSI/NFPA 58. Your local library or re department
should have this book.
7
8
9
9
Q
S
C
A B
E
G
G
D
J
I
G
E
B
B
A
A