Owner Manual
Contact us for assistance: (866) 985-7877 | www.wtliving.com 5
Aach
L
to
K
. Align holes in with
corresponding holes in , and insert 3
N
through
holes and nger-ghten. Repeat with second . Tighten with wrench
once both have been aached. Note: 6 - M6x16 Bolts
N
come
pre-assembled to the base. You will need to loosen and remove them to
complete this assembly.
Hardware Used: 6x Bolt M6x16
Aach the
J
to the
K
. Align the holes in the
boom of each with the hole on the . Insert 1
M
through the hole in the support and into the and
hand ghten. Repeat with the other 2 and then ghten
all bolts with a wrench. Note: 3 - M8x16 Bolts
M
come pre-assembled
to the base. You will need to loosen and remove them to complete this
assembly.
Hardware Used: 3x Bolt M8x16
Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents list and
hardware contents as listed on page 4 of this manual. If any part is missing or damaged, do not aempt to assemble this product.
Contact customer service for replacement parts.
Phillips screwdriver w/medium blade, Leak Detecon Soluon, Adjustable wrench (2)
(Note: 10mm wrench or socket should t M6 bolt; 13mm wrench or socket should t M8 bolt.)
NOTE: This heater has an Electronic Ignion and will require installaon of 1 – AAA baery. The baery should be installed
by unscrewing the RED IGNITER BUTTON.
1
2
K
L
L
N
N
K
M
J