Owner Manual

Contact us for assistance: [phone] | www.wtliving.com 12

To enjoy years of outstanding performance from your heater, make sure you perform
the following maintenance acvies on a regular basis:

1. Use soapy water for cleaning. Never use ammable or corrosive cleaning
agents.
2. While cleaning your unit, be sure to keep the area around the burner and
control compartment dry at all mes. Do not submerge the control valve
assembly. If the gas control is submerged in water, do NOT use it. It must
be replaced.
3. Air ow must be unobstructed. Keep controls, burner, and circulang air
passageways clean. Signs of possible blockage include:
• Gas odor with extreme yellow pping of ame.
• Heater does NOT reach the desired temperature.
• Heater glow is excessively uneven.
• Heater makes popping noise.
• Spiders and insects can nest in burner or orices. This dangerous
condion can damage heater and render it unsafe for use. Clean
burner holes by using a heavy-duty pipe cleaner. Compressed air may
help clear away smaller parcles.
• Carbon deposits may create a re hazard. Clean dome and burner
screen with warm soapy water if any carbon deposits develop.
Note: In a salt-air environment (such as near an ocean), corrosion occurs more quickly
than normal. Frequently check for corroded areas and repair them promptly.

Only a qualied service person should
repair gas passages and associated
components.
Cauon: Always allow heater to cool
before aempng service.
:

• Turn control knob OFF.
• Disconnect LP source.
• Store heater in an area sheltered
from direct contact with inclement
weather (such as rain, sleet, hail,
snow, dust and debris).
• If desired, cover heater to protect
exterior surfaces and to help
prevent build-up in air passages.
Never leave LP cylinder exposed to
direct sunlight or excessive heat.
Note: Wait unl heater is cool
before covering.


• Turn control knob OFF.
• Disconnect LP source and move to
a secure, well-venlated locaon
outdoors.
• Store re pit in an area sheltered
from direct contact with inclement
weather (such as rain, sleet, hail,
snow dust and debris).
• If desired, cover re pit to protect
exterior surfaces and to help
prevent build-up in air passages.
Never leave LP cylinder exposed to
direct sunlight or excessive heat.
Wait unl re pit is
cool before covering.
WARNING
FOR YOUR SAFETY
•
Do NOT touch or move heater for at least 45
minutes aer use.
•
Burner and housing are hot to the touch.
•
Allow burner and housing to cool before
touching.