Owner's Manual

Contact us for assistance: [phone] | www.wtliving.com 5
ASSEMBLY
*
Sandbox: This heater comes with a sandbox pre-assembled to the base. To fill the
sandbox, pull open the plastic cap on top of the sandbox and fill with water or
sand (sand is recommended if the heater will be exposed to freezing temperatures).
Replace the plastic cap. You may find it easier to fill the sandbox prior to attaching
wheels.
In the event that you need to remove or replace the sandbox, remove the 4 Large
Screws and Large Nuts that secure the base to the sandbox, then lift the base off of
the sandbox. To re-install, place Base back over the sandbox and align the holes in
the base with the holes in the sandbox. Insert Large Screws through the holes in the
base and secure by tightening Large Nuts on ends of the bolts.
1
Attach Wheel Assembly
K
to Base
J
. Align holes in
Wheel Assembly with corresponding holes in Base,
and insert 2 Small Bolts through the holes and nger tighten.
Be sure that the Wheel Assembly is parallel to the Base
J
and tighten with the Wrench.
Hardware Used: 2x Small Bolts
2
Attach the Post Supports
I
to the Base
J
. Align the holes
in the bottom of each Post Support with the hole on the
Base. Insert 1 Small Bolt through the hole in the support and
into the Base and hand tighten. Repeat with the other 2 Post
Supports and then tighten all bolts with the Wrench.
Hardware Used: 3x Small Bolts
Plastic Cap
Sandbox
Base
PREPARATION
Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents list
and hardware contents as listed on page 4 of this manual. If any part is missing or damaged, do not attempt to assemble
this product. Contact customer service for replacement parts.
ESTIMATED ASSEMBLY TIME: 60 minutes
Tools Required for Assembly (NOT included):
• Phillips screwdriver w/medium blade • Leak test solution (see page 10)