Installation Guide

Contact us for assistance: [phone] | www.wtliving.com
6
ASSEMBLY
3
Attach Anchoring Arm
P
to the base of the Tank
Assembly
E
with 2 pieces of M6x12 Bolt
R
and M6
Nut
H
. Note: If you are using the Wheel Assembly
F
, you will
only be able to attach 2 Anchoring Arms to the base. Once
you have completed assembly of the heater, you can use the
Anchoring Arm/Pin to secure the heater to the ground by
inserting an Anchoring Pin
Q
through the hole in the Anchoring
Arm
P
and into the ground.
Hardware Used: 3x Anchoring Arm
3x Anchoring Pin
6x M6x12 Bolt
6x M6 Nut
4
Attach 4 - Protection Guards
C
to the holes on top of Tank
Assembly
E
. Use 8 - M6 Nuts
H
to secure Protection
Guards.
Hardware Used: 8x M6 Nut
5
Insert 3 - M8 Bolts
K
into holes on Reector
A
.
Tighten Bolts securely. Attach 3 - M8 Washers
I
over the Bolts, place the Reector onto the Bolts and
attach 3 - M8 Washers
I
over Bolts and onto Reector.
Secure with 3 - Wing Nuts
J
. Do not over tighten.
Hardware Used: 3x M8 Bolt
6x M8 Washer
3x M8 Wing Nut
3
4
5
P
H
R
C
E
K
I
I
J
A
H
E